I finally got around to installing my walbro fuel pump and adjustable regulator. The regulator has a single input, so I used a Y Fuel block to route the fuel lines off both rails into one. I have a gauge both on the regulator & the Y Block. At the same time, I replaced my spark plug wires since one was burnt up.
I can crank the car like normal, but it doesnt start now. Im getting fuel to the Y block. So the pump is working. Im gonna check & ensure the spark plug wires are tight (especially the 2/4/6 side, since its real tight there). Then run some codes. Im not sure what to place the adjustable regulator at. Should I start with it all the way loose or tight? I have the vac line hooked up, should I try removing it? What are some other things I should check?
I can crank the car like normal, but it doesnt start now. Im getting fuel to the Y block. So the pump is working. Im gonna check & ensure the spark plug wires are tight (especially the 2/4/6 side, since its real tight there). Then run some codes. Im not sure what to place the adjustable regulator at. Should I start with it all the way loose or tight? I have the vac line hooked up, should I try removing it? What are some other things I should check?
Comment