Asking on behalf of another SS owner that when he went to install the PRW2 upgrade module, swapped the wrong two wires and bricked his car. It cranks, but there is no spark at the coil.
Unfortunately I've not had to troubleshoot anything like this personally, so i'm at a loss. I know he has tried a replacement: ECU, CAS, PRW2 module.
I've been able to help in as far as i can look at the wiring schematic and see that the three wires from the module go to pins 3 & 5 of the ECU and ground, and that's where my experience ends.
Sorry for the vague post, but i'm sure someone has done this before, i just don't know where to look for a failed part.
Unfortunately I've not had to troubleshoot anything like this personally, so i'm at a loss. I know he has tried a replacement: ECU, CAS, PRW2 module.
I've been able to help in as far as i can look at the wiring schematic and see that the three wires from the module go to pins 3 & 5 of the ECU and ground, and that's where my experience ends.
Sorry for the vague post, but i'm sure someone has done this before, i just don't know where to look for a failed part.
Comment