Got it set up and everything went just like the instructions said it would.
Then I hooked up the RPM converter through my Tach signal on my TECII and programed it the easy way(more than one way to program rpm's). At first it would just read a voltage for my RPM's???? SO I went to innovates forum did some searching and bingo found out I had to configure the accessory of the LM-1 so it knew that it was an rpm converter that it was reading.
Now I just gotta fix the 18:1 afr at 5lbs of boost!!!!! :shock: :shock: :shock:
I know I've said it before but damn there is so much info on the innovate forum. I have yet had the need to post a question. I just do searches and allways find the answer i'l looking for!
Then I hooked up the RPM converter through my Tach signal on my TECII and programed it the easy way(more than one way to program rpm's). At first it would just read a voltage for my RPM's???? SO I went to innovates forum did some searching and bingo found out I had to configure the accessory of the LM-1 so it knew that it was an rpm converter that it was reading.
Now I just gotta fix the 18:1 afr at 5lbs of boost!!!!! :shock: :shock: :shock:
I know I've said it before but damn there is so much info on the innovate forum. I have yet had the need to post a question. I just do searches and allways find the answer i'l looking for!
Comment