I've been seeing maf voltages up around 5-5.5v and know I'm not moving that much air. So after some discussion and digging around the nistune forum I found reference to a different offset for Z32 N62 maf's.
Basically, I'm saying if you are using a Z31 ecu and a Z32 maf with the three resistors removed from the check circuit, you need to open your address file in notepad and change the "LEGACY_AFM_OFFSET=1500" to "0" or remove this entry entirely. I cannot say if this applies to any other meters at this time.
This is only a software concern for calculations in the nistune software. It has no other implication for other tuning methods.
Basically, I'm saying if you are using a Z31 ecu and a Z32 maf with the three resistors removed from the check circuit, you need to open your address file in notepad and change the "LEGACY_AFM_OFFSET=1500" to "0" or remove this entry entirely. I cannot say if this applies to any other meters at this time.
This is only a software concern for calculations in the nistune software. It has no other implication for other tuning methods.
Comment