Announcement

Collapse
No announcement yet.

data logging problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • data logging problem

    my rpm signal is jumpy. My car is at idle and ever now and again the rpm signal jumps to 8K. WTF is going on here. I'm pulling the rpm from pin 3 on the ecu is this ok or could I be getting interferance from something??







    oh and the rpm signal gets really jumpy when I rev the engine.


    tbs
    Blue & Silver 81 zxt, 88 ECCS
    Z32 mas,450cc injectors
    ported exhaust manifold, cable throttle linkage
    t3/t4e 12psi , 3inch exhaust, K&N,
    ACT clutch, 240sx t/b, 1G DSM BOV
    Custom Intake FINISHED
    Ported and Polished N42
    Tan 88-89 conquest seats
    Sperco IC 18.5x6x3.5
    2.5 IC pipes
    Suspension work!!
    Nistune
    Zeitronix Wideband
    240sx transmission
    Soon:
    95 Maxima Alternator

  • #2
    TBO recently answered this verbosely on z31.com

    Comment


    • #3
      ok I'm lost went over to z31.com and read up on what to do. some box by the brake master cylinder. But my Z31 box is in a 280zx and I not clear. does anyone have a wiring diagram handy? Or can I pull the signal from the tach?



      tbs
      Blue & Silver 81 zxt, 88 ECCS
      Z32 mas,450cc injectors
      ported exhaust manifold, cable throttle linkage
      t3/t4e 12psi , 3inch exhaust, K&N,
      ACT clutch, 240sx t/b, 1G DSM BOV
      Custom Intake FINISHED
      Ported and Polished N42
      Tan 88-89 conquest seats
      Sperco IC 18.5x6x3.5
      2.5 IC pipes
      Suspension work!!
      Nistune
      Zeitronix Wideband
      240sx transmission
      Soon:
      95 Maxima Alternator

      Comment


      • #4
        The Z31 FSM's are available for download here:

        http://carfiche.com/manuals020/cars/

        I'm really not sure if the actual tach signal at the tach will work...

        Comment


        • #5
          ok I moved my rpm location and still I'm getting spikes! Note I'm also running the four wire trigger if this turns out to be a problem I'll grab a three wire out of my stash and wire it up. but here is the location I moved it to if this is still wrong will some one please mark the picture and repost or send it to me.





          tbs
          Blue & Silver 81 zxt, 88 ECCS
          Z32 mas,450cc injectors
          ported exhaust manifold, cable throttle linkage
          t3/t4e 12psi , 3inch exhaust, K&N,
          ACT clutch, 240sx t/b, 1G DSM BOV
          Custom Intake FINISHED
          Ported and Polished N42
          Tan 88-89 conquest seats
          Sperco IC 18.5x6x3.5
          2.5 IC pipes
          Suspension work!!
          Nistune
          Zeitronix Wideband
          240sx transmission
          Soon:
          95 Maxima Alternator

          Comment


          • #6
            I got it fixed I read up on innovatives forum and the spikes are called coil ringing and because of the low voltage that the wideband works on it needed a 10-50kohm potentiometer to adjust the resistance going in and it eliminated the spikes.





            tbs
            Blue & Silver 81 zxt, 88 ECCS
            Z32 mas,450cc injectors
            ported exhaust manifold, cable throttle linkage
            t3/t4e 12psi , 3inch exhaust, K&N,
            ACT clutch, 240sx t/b, 1G DSM BOV
            Custom Intake FINISHED
            Ported and Polished N42
            Tan 88-89 conquest seats
            Sperco IC 18.5x6x3.5
            2.5 IC pipes
            Suspension work!!
            Nistune
            Zeitronix Wideband
            240sx transmission
            Soon:
            95 Maxima Alternator

            Comment


            • #7
              did you consider using the 120 degree line of the CAS for a tach signal instead?
              88ss, MegaSquirted.
              t3/t4 60-1 cold, stage 3 hot, FMIC
              450cc DSM injectors, walbro 255
              http://www.z-toys.com/ Boost gauge and MS info

              Comment


              • #8
                can I use that? if I can which pin was it and I'll do that








                tbs
                Blue & Silver 81 zxt, 88 ECCS
                Z32 mas,450cc injectors
                ported exhaust manifold, cable throttle linkage
                t3/t4e 12psi , 3inch exhaust, K&N,
                ACT clutch, 240sx t/b, 1G DSM BOV
                Custom Intake FINISHED
                Ported and Polished N42
                Tan 88-89 conquest seats
                Sperco IC 18.5x6x3.5
                2.5 IC pipes
                Suspension work!!
                Nistune
                Zeitronix Wideband
                240sx transmission
                Soon:
                95 Maxima Alternator

                Comment


                • #9
                  On the Z31, it's the green and black wire coming off the CAS; the green/yellow wire is the one degree signal. At the ECU, pin 17 is 120 degree, pin 8 is 1 degree.
                  88ss, MegaSquirted.
                  t3/t4 60-1 cold, stage 3 hot, FMIC
                  450cc DSM injectors, walbro 255
                  http://www.z-toys.com/ Boost gauge and MS info

                  Comment


                  • #10
                    thanks I'll try that tonight.




                    tbs
                    Blue & Silver 81 zxt, 88 ECCS
                    Z32 mas,450cc injectors
                    ported exhaust manifold, cable throttle linkage
                    t3/t4e 12psi , 3inch exhaust, K&N,
                    ACT clutch, 240sx t/b, 1G DSM BOV
                    Custom Intake FINISHED
                    Ported and Polished N42
                    Tan 88-89 conquest seats
                    Sperco IC 18.5x6x3.5
                    2.5 IC pipes
                    Suspension work!!
                    Nistune
                    Zeitronix Wideband
                    240sx transmission
                    Soon:
                    95 Maxima Alternator

                    Comment


                    • #11
                      8)

                      Comment


                      • #12
                        moved to pin 17 with no problems thanks guys






                        tbs
                        Blue & Silver 81 zxt, 88 ECCS
                        Z32 mas,450cc injectors
                        ported exhaust manifold, cable throttle linkage
                        t3/t4e 12psi , 3inch exhaust, K&N,
                        ACT clutch, 240sx t/b, 1G DSM BOV
                        Custom Intake FINISHED
                        Ported and Polished N42
                        Tan 88-89 conquest seats
                        Sperco IC 18.5x6x3.5
                        2.5 IC pipes
                        Suspension work!!
                        Nistune
                        Zeitronix Wideband
                        240sx transmission
                        Soon:
                        95 Maxima Alternator

                        Comment

                        Working...
                        X