Nistune Low impedence 550cc RX7 injectors question

[BLITZERKING1]

So I have an 87 NA auto ECU that has Nistune installed on it and it has an 88 turbo ROM on it. Can I run my low impedence RX7 injectors on it without dropping resistors? I know the 87 NA ECU takes low impedence injectors but an 88 turbo uses high impedence. My car is an 84 turbo

[shromy]

no, gotta have resistors

[BLITZERKING1]

no, gotta have resistors

Ok. I'll probably just put the 87 turbo ROM on it then and use my injectors without dropping resistors

[BLITZERKING1]

no, gotta have resistors

I asked Alex this question. This is what he said "The ECU is still an 87 ECU. The tune doesn't give any bearing on what type of injectors it requires. It's a hardware thing on the ECU.

So you'll still need low impedance injectors."

[shromy]

your correct, i must have read wrong. peak and hold aka low ohm drivers can run both low and high impedance.