So after Matt from nistune answered some questions he recommended I switch to a standalone. Thinking of grabbing a haltech 2500. Would love to find a male pin pigtail/connector that would match our ECU so I can just wire it up without cutting the original harness. Is anyone using a haltech and found an easy way?
Announcement
Collapse
No announcement yet.
Haltech wire harness
Collapse
X
-
Finding an inline variation of that vintage of a connector could be nearly impossible, but you could make your own by desoldering the connectors off of a donor ECU and soldering them to a perfboard, making your own break-out board.
A few years ago i did some disassembly of one and found that the FI connector was made by AMP, but the others i could not determine.
-
Yeah you could totally use jumpers into the Z31 harness plugs and then pot them in place, as long as like you said, pin diameter is correct and makes a good contact.
Comment
Comment