i have been looking though the factory service manual on how to adjust the throttle switch.
in the manual all i can find is set the switch until there is continuity.
i got my trust multimeter out. switched it to 200 ohms range. the highest value i could get out of the switch is 2 ohms. is this normal. what is everyone else setting theres to?
just on a side note, i have removed all the smog crap and the idle contols. they were driving me nuts. everything is blocked off with a plate. i set my idle with that little screw and nut on the butterfly valve. i have my idle set around 900 rpm. that way it'll start when its below zero.
in the manual all i can find is set the switch until there is continuity.
i got my trust multimeter out. switched it to 200 ohms range. the highest value i could get out of the switch is 2 ohms. is this normal. what is everyone else setting theres to?
just on a side note, i have removed all the smog crap and the idle contols. they were driving me nuts. everything is blocked off with a plate. i set my idle with that little screw and nut on the butterfly valve. i have my idle set around 900 rpm. that way it'll start when its below zero.
Comment