I have the AEM gauge/controller and all the jazz that comes with it.
The controller comes with a standard/default setting of 0volts=10:1 and 4volts= 18:1
I can change it to run opposite but only in a 1v range. example, .905v=10:1 and .070 =18.5:1 This is the only way that the TEC will read the information, lean =0v and rich =5v
do most standalones read this way? the 0-1v signal (just like an oem narrow band) 0v being lean and 1v being rich.
I can calibrate the TECII to read it how I want but only with 0v being rich and 5v being lean(it wont let me do the opposite). HOWEVER in the calibration table it gives me an option to use a full 5 volts which I dont understand if the TEC only read 0-1v anyways. The default calibration on the TEC also uses the full 5volts in the graph which I dont understand. Anybody got any ideas on this?
Or does this not make any sence to anyone?
The controller comes with a standard/default setting of 0volts=10:1 and 4volts= 18:1
I can change it to run opposite but only in a 1v range. example, .905v=10:1 and .070 =18.5:1 This is the only way that the TEC will read the information, lean =0v and rich =5v
do most standalones read this way? the 0-1v signal (just like an oem narrow band) 0v being lean and 1v being rich.
I can calibrate the TECII to read it how I want but only with 0v being rich and 5v being lean(it wont let me do the opposite). HOWEVER in the calibration table it gives me an option to use a full 5 volts which I dont understand if the TEC only read 0-1v anyways. The default calibration on the TEC also uses the full 5volts in the graph which I dont understand. Anybody got any ideas on this?
Or does this not make any sence to anyone?
Comment