So, I have run an oil feed line for my hx35 setup and am leery about the bends that had to be put in the line. My shop was telling me something about not making the hose do the bends but rather have the fittings do so. I don’t think that there should be a problem with this setup, seeing that the bends in the hose are no tighter than the bends in the 90 degree fittings, but it isn't something I want to risk. Anyway, here is a picture of the setup. I have made an imaginary red line where the oil line goes. (Yes, I plan on using an EBC but if I don't have the money when its time to put the motor back in, the MBC will do for now):

Comment