Announcement

Collapse
No announcement yet.

rear bumper skin install

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • rear bumper skin install

    I'm in process of reattaching the rear facia of my Z (1988). Are there any tips from those that have done this before on keeping the attachment brackets in place while positioning the skin? The upper one feels tight in the holes, as in the threads are rubbing on the skin, and the side ones keep falling out, with no backside access when the facia is in place.
    --------------
    Legal stuff:
    **Nissan Employee**
    Any information shared is simply my own opinion and NOT the opinion of Nissan

    not legal stuff:
    '88 300ZX 2+2-- Still under the knife but close to done
    '22 Q60RS-- I tell the wife it's hers...
    '23 Maxima SR
    '87 Chaparral bowrider-- the next project
    '00 Corolla-- kids car.
    '16 F-150-- Another kids car
    '14 E-350-- Gotta haul those kids in something. I still hate Fords, but it was cheap.

  • #2
    double sided tape.

    Comment


    • #3
      figured it out. Install the brackets inside the bumper skin. Then install those pesky rubber washers on the studs-- they hold the brackets in place. then install the skin to the car. Thanks for the response!
      --------------
      Legal stuff:
      **Nissan Employee**
      Any information shared is simply my own opinion and NOT the opinion of Nissan

      not legal stuff:
      '88 300ZX 2+2-- Still under the knife but close to done
      '22 Q60RS-- I tell the wife it's hers...
      '23 Maxima SR
      '87 Chaparral bowrider-- the next project
      '00 Corolla-- kids car.
      '16 F-150-- Another kids car
      '14 E-350-- Gotta haul those kids in something. I still hate Fords, but it was cheap.

      Comment


      • #4
        Well done, I used double sided tape for it

        Comment

        Working...
        X