Announcement

Collapse
No announcement yet.

PowerSteeringPump

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • PowerSteeringPump

    Both of my electrical cables on my power steering pressure switch at the pump have been severed.

    What is the correct "connecting" wire to wire I need to follow?

    Manual does not state and I can not remember for the life of me which colored wire goes to which.

    I have one wire which is "yellow with a green stripe" and another which is "orange with red rings" off the pwrstrswitch, and the wires on the harness are "full green" and "full red" in color.

    I am guessing yellow & green goes to full green and orange & red goes to full red?

    Anyone?

  • #2
    I just checked my 2 cars that are here and 3 other power steering pumps only to find non of them have the switch. ¯\_(ツ)_/¯

    But, the FSM does show that the switch doesn't pull a signal to chassis ground at the pump, which indicates it's insulated, which means that polarity doesn't matter.
    That being said, i'd match the colors anyway.


    84 AE/Shiro #683/Shiro #820/84 Turbo

    Comment


    • #3
      Tracking.

      Thank you Z_Karma for following in - I did not want to over think this. ¯\_o_0_/¯

      Comment

      Working...
      X