A good buddy of mine has been working on installing an Isuzu NPR intercooler in his 1986 300ZXT. He had the intercooler piping under control, but needed a hand on the compressor inlet piping. So, I put my skills to work once again and fab'd up another pipe that runs under the motor mount.

NOTICE my custom front strut tower brace too!


Now here's the magic. 2.5" straight piping, cut at 10 degrees on each side and welded together to produce an "S" curve that will wind around the bottom of the motor mount.


more pictures on my website
Oh, and here's the intercooler that is going on the 1986 2x2 for the NA to turbo swap. It fits perfectly. I got a REALLY good deal on it through EllisAutoWorkZ, so talk to them if you want one as well.

21x9x2.75, 2.5" inlet/outlet
Now, it's time to drink that beer!
Peace!
NOTICE my custom front strut tower brace too!
Now here's the magic. 2.5" straight piping, cut at 10 degrees on each side and welded together to produce an "S" curve that will wind around the bottom of the motor mount.
more pictures on my website
Oh, and here's the intercooler that is going on the 1986 2x2 for the NA to turbo swap. It fits perfectly. I got a REALLY good deal on it through EllisAutoWorkZ, so talk to them if you want one as well.
21x9x2.75, 2.5" inlet/outlet
Now, it's time to drink that beer!
Peace!
Comment