im just getting started on replacing my leaking stock oil cooler lines with braided stainless hose and i have a couple questions.. i looked at the ports coming off of the adapter thats bolted to the block. i didnt have any measuring tools, but im guessing they are 18X1.5.. does anyone know this size for sure? how about the ports on the cooler itself? also, -8 or -10 hose? i think im gonna use -8..
my plan so far is as follows: metric to An adapters off of the adapter block to braided hose, to bulkhead fitting to pass through the fender.. then braided lines to metric adapters at the cooler. hopefully i can find all the correct metric adapters and not have to use any weld fittings..
if anyone has this information it would be very helpful, otherwise i will measure everything and post it with pictures when i am done. thanks
my plan so far is as follows: metric to An adapters off of the adapter block to braided hose, to bulkhead fitting to pass through the fender.. then braided lines to metric adapters at the cooler. hopefully i can find all the correct metric adapters and not have to use any weld fittings..
if anyone has this information it would be very helpful, otherwise i will measure everything and post it with pictures when i am done. thanks
Comment